Shower Enclosure Fittings
Frameless shower enclosures need fittings that hold heavy glass in a wet room for years. Our SS 304 connectors and hinges come in steel, black, rose gold and gold, with seals and support rods to finish the job.
Glass Connector
SS 3045 itemsGlass connectors (also called glass clamps) join fixed glass panels to each other or to a wall at a set angle. They are the small square clamps you see on shower enclosures, glass partitions and display units. Black · Rose Gold · Gold available
How it is used
- Drill one hole in the glass at the clamp position, as per the clamp template.
- Fix one side to the wall (U or L connectors) or clamp both glass panels (180°, 90°, 135°).
- Insert gaskets on both faces of the glass and tighten the cover screws.
Where it is used
- Shower enclosures and bathroom partitions
- Office glass partitions and corners
- Glass shelves, counters and display units
- Balcony and staircase glass panels
How to choose
- Choose the angle by layout: 180° for a straight run, 90° for corners, 135° for angled bays.
- U connector fixes a glass edge to a wall or floor; L connector holds the glass at a wall corner.
- Black, Rose Gold and Gold finishes match coloured shower fittings.
Glass to Glass 135° Connector
Joins two glass panels at 135°, for angled and bay-shaped enclosures.
Shower Hinges
SS 3047 itemsShower hinges carry a frameless glass shower door and let it swing. Addmore hinges are SS 304 with self-centering action, made for wet areas. Black · Rose Gold · Gold available
How it is used
- Glass is notched and drilled to the hinge template before toughening.
- Wall-to-glass hinges are screwed to the tile wall with plugs; glass-to-glass hinges clamp to a fixed panel.
- Use two hinges per door (three for tall or heavy doors) and align them on one axis.
- Seal the bottom and the closing edge with PVC or magnetic seals.
Where it is used
- Bathroom shower enclosures
- Wet rooms and steam rooms
- Hotel and hospital bathrooms
- Gym and spa changing areas
How to choose
- Wall to glass 90° hinges (ASH-22, ASH-33) for doors hinged on a wall.
- Glass to glass hinges (ASH-44, 55, 66) when the door hangs off a fixed glass panel at 180°, 90° or 135°.
- ASH-77 T-type hinge handles two doors plus a fixed panel at one point.
Wall to Glass 90° Fix Bracket
Fixed wall bracket at 90° for holding a fixed glass panel to the wall.
Wall to Glass 90° Offset Hinge
Wall-to-glass hinge with offset back plate, for 90° door swing from a wall.
Glass to Glass 180° Hinge
Glass-to-glass hinge for a door hung off a fixed panel in a straight line.
Glass to Glass 90° Hinge
Glass-to-glass hinge for a door hung off a fixed panel at a 90° corner.
'T' Type Hinge for 2 Door 180° and 1 Fix 90°
T-type hinge for two doors at 180° plus a fixed panel at 90°, all at one point.
Shower Towel Bar Handles
2 itemsA towel bar handle is a long pull handle on the outside of a shower door with a towel bar on the inside. It gives a good grip on wet glass and a place to hang a towel. Black · Rose Gold · Gold available
How it is used
- Drill holes in the glass at the specified centres before toughening.
- Pass the bolts through the glass with nylon sleeves and washers on both sides.
- Tighten until firm; do not over-tighten on the glass.
Where it is used
- Shower doors
- Bathroom glass partitions
- Spa and gym shower cubicles
How to choose
- ASH-03 is SS 304 and better for coastal or very humid areas than SS 202.
- Round and square styles; pick the one that matches your hinges.
Round Type Shower Handle
Round towel-bar handle for shower doors. Pull handle outside, towel bar inside.
Square Type Shower Handle
Square towel-bar handle for shower doors with a modern square profile.
Shower Header Accessories
6 itemsShower header accessories make a 19 mm stabiliser rod between the top of a glass panel and the wall. The rod stops a tall fixed glass panel from flexing. Black · Rose Gold · Gold available
How it is used
- Fix the wall connector (ASA-10) to the wall and the glass connector (ASA-20 or ASA-30) at the top edge of the glass.
- Cut the 19 mm rod (ASA-60) to length and push it into both connectors.
- Use ASA-40 or ASA-50 to join rods around corners or to three points.
Where it is used
- Frameless shower enclosures with tall fixed panels
- Glass partitions that are not fixed at the ceiling
- Bathroom glass screens
How to choose
- One support bar is normal for panels above 1.8 m with no ceiling fixing.
- Black, Rose Gold and Gold finishes are available to match hinges.
Pipe to Glass Connector (One Side Blind)
Holds the rod end at the glass with one closed side for a neat finish.
Pipe to Pipe Connector (2 Way Connecting Rod)
Swivel connector joining two rods at any angle.
Shower Door Knobs
SS 3041 itemA back-to-back knob for glass shower and cabinet doors. Compact and easy to grip from both sides.
How it is used
- Drill a single hole in the glass.
- Pass the bolt through with sleeves and washers, then tighten the two knobs together.
Where it is used
- Shower doors
- Steam room doors
- Small glass cabinet doors
How to choose
- Use a knob where a full-height handle is too large, such as narrow shower doors.
PVC & Magnetic Seal
7 itemsPVC and magnetic seals close the gaps around frameless shower glass. They keep water in the shower and stop doors from rattling. Black · Rose Gold · Gold available
How it is used
- Measure the glass edge and cut the seal to length with a fine blade.
- Push the seal onto the glass edge; it grips without glue.
- Magnetic seals are fitted in pairs, one on the door and one on the fixed panel, so the door closes with a soft magnetic catch.
Where it is used
- Bottom of shower doors (D, F, Y and water dispersal seals)
- Closing edge between door and fixed panel (magnetic seals)
- Between two doors (center seal)
How to choose
- Choose 2.2 m or 2.5 m length to suit door height.
- Seals suit 8, 10 and 12 mm glass; tell us the thickness when ordering.
- Use AMS-01 for 180° door to panel and AMS-02 where they meet at 135°.
Y Seal (Soft / Hard)
Y seal with soft and hard fins, sweeps water at the door bottom.
Water Dispersal Seal
Water dispersal seal with a drip lip that keeps water inside the shower.
Not sure which one fits?
Send your door size, glass thickness and photos. We will suggest the right fittings.